CTC-1132 868AM 2007.07.18
15
F i n a l D o o r O f f
F i n a l D o o r O n
z Press “S” & “T” keys to select the option.
z Press “OK” to confirm.
z “FinalDoor On” (Final Door Set Option On)
is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
When “Final Door Arming” is programmed,
the Control Panel will arm after the entry door
is closed. For more description of this feature,
please refer to Sec. II “Away (Alarm On)
Mode” of “Operation”
9. Interference
Turn on and off the detection feature of
interference.
D e t e c t i o n O f f
D e t e c t i o n O n
z Press “S” & “T” keys to select the option.
z Press “OK” to confirm.
z “Detection Off” is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
) When the “Detection On” is selected,
whenever the signal jamming period
lasted longer than 30 seconds, this
fault event will be logged, and
displayed on the LCD to warn the user.
) When the “Dectection Off” is selected,
CTC-1132 will not check interference
status.
10. Remote Controller Entry Enable
Turn on and off the Remote Controller disarm
function.
R C E n t E O f f
R C E n t E O n
z Press “S” & “T” keys to select the option.
z Press “OK” to confirm.
z “Remote Controller Entry Enable off” is
set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
) When the “Remote Controller Entry
Enable” is set to “Off” it will not be
possible to disarm the Control Panel
when the system is fully armed unless
an entry point device is activated first.
This feature is used to ensure that the
system cannot be disarmed with a
stolen Remote Control without
unlocking a door first.
) When the “Remote Controller Entry
Enable” is set to “On”, the Remote
Controller can Arm and Disarm the
Control Panel as normal without
activating an entry point first.
11. Mobility
This is to disable or enable the Mobility Timer
with selected countdown period. Options
available are Disable, 4 hours, 8 hours and
12 hours.
If the Mobility Timer is enabled, it will count
down the pre-programmed time length. When
the timer times out without being reset, a report
will be made to the Programmed phone
numbers.
Disab l e
4 Hrs
8 Hrs
12 Hr s
z Use “T” & “S” keys to select the options.
z Press “OK” to confirm.
z “Disable” is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
) When the “Mobility” is set with a
specified timer, the Control Panel will
report to the Programmed phone numbers
when the timer runs out unless one of the
following actions occurred in advance to
reset the timer:
In “Home” mode: whenever any
“Home Omit” DC, IR is triggered, or
whenever any of the keys of the
Control Panel is pressed
In “Disarm” mode: whenever any of
the DC or IR (except 24 Hr, Fire,
Medical Emergency and Water) is
triggered, or whenever any of the keys
of the Control Panel is pressed
) When the system is set to “Away Arm”,
the timer automatically stops. When the
To Next Page
Loading...