CTC-1132 868AM 2007.07.18
39
acknowledgement signal being received. If
the recipient does not acknowledge the
call, the message will be repeated for a
period of 80 seconds; the Control Panel
will then consider the call as unsuccessful
and will try to dial the next phone number
in priority.
z If more than one number is programmed
the Control Panel will continue to dial the
number(s) until two emergency calls are
successfully answered with either keys or
“0”, or closed down with a key “9”
acknowledgement.
<
<
N
N
O
O
T
T
E
E
>
>
) CTC-1132 Auto-Dialling features only
operate under Tone-Dialling method.
2. Call Acknowledgment
z If the recipient successfully receives the
call, the recipient should acknowledge it by
pressing the DTMF "0" or "9" button on
the telephone set..
Acknowledging with signal 0
If the recipient presses "0" on the phone
set as the acknowledging signal. The
Control Panel will take the following
actions.
9 The Control Panel will go back
on-hook.
9 The Control Panel will continue
alarming.
9 The Control Panel will try to dial
the phone numbers of the next
priorities until two recipients
have acknowledged the call.
Acknowledging with signal 9
If the recipient presses "9" on the phone
set as the acknowledging signal, the
following will happen:
9 The Control Panel will go back
on-hook.
9 The Control Panel will stop
alarming and stop dialing.
3.Auto Redial
z When only one Emergency phone number
is stored and that number is engaged, the
Control Panel will automatically redial that
number up to maximum of 5 times with an
interval of 62 sec. between dialing
attempts.
z When more than one telephone numbers
are stored, the Control Panel will dial in
accordance to the set priority order. If the
number being dialed is engaged, it will try
the next number. Each number will be
tried a maximum of 5 times and the redial
interval between each number is 5 sec.
z The maximum number of times the Control
Panel will retry is 15 times.
<
<
N
N
O
O
T
T
E
E
>
>
) If no phone Number is programmed,
the Control Panel will not dial.
)
When dialing a pager number, the
Control Panel will only send the
identity code, it will not play the
message and the call is not
considered to be successful.
) The same pager number will be dialed
only once.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution :
To assure continued compliance, any changes or modifications
not expressly approved by the party responsible for
compliance could void the user's authority to operate this
equipment. (Example - use only shielded interface cables
when connecting to computer or peripheral devices).
To Next Page
Loading...