CTC-1132 868AM 2007.07.18
22
4. Program Siren
If an outdoor Bell Box, Indoor Bell Box or
Universal Receiver etc. is to be included in the
system, it should be programmed first by the
Control Panel, so that the Control Panel can
communicate with these auxiliary devices.
To program these auxiliary devices, select
“Program Siren” in the “Device +/-“ menu.
L e a r n S i r e n
S i r e n T a m p . O n
S i r e n T a m p . O f
C o n f i r m O n
C o n f i r m O f f
E n t r y S n d O n
E n t r y S n d O f f
R e c e i v e r 1
R e c e i v e r 2
z Learn Siren
z If there is any detector or Remote
Controller has been added already,
Step 1. Put all the desired Auxiliary devices
into learn mode (Refer to their
individual Operational Manual).
Step 2. Move the cursor to the position
“Learn Siren”.
Step 3. Press “OK”.
Step 4. The Control Panel will then sound a
long beep and transmit Learning code
to all devices simultaneously. The Out
Door Bell Box (BX-8) should respond
by activating its siren & strobe light
momentarily while the UR-7 status
LED lights up for 3 seconds.
Step 5. Place these auxiliary devices out of
Learn mode. Adding them into the
system is completed.
<
<
N
N
O
O
T
T
E
E
>
>
) If any of these devices does not
respond, make sure that the device is
in learn mode and repeat the steps
again.
) After they are added in, every time
pressing a PIN code & followed by
“OK” key will result in the Control
Panel transmitting signal to all of them
) If there is no other detector or Remote
Controller being added first, the
following message will be displayed in
Step 3.
P l e a s e a d d
o n e d e v i c e
The message will be displayed for 2
sec. then the screen returns to
“Device +/-“ menu. You are
requested to add a detector or
Remote Controller first then you can
try programming these auxiliary
devices again.
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
For the following options, whichever option
is selected, when the Control Panel
transmits the signal, all added sirens will
simultaneously received the signal and all
will acted accordingly
z Siren Tamp.On, Siren Tamp.Off
The Outdoor Siren BX-8tamper switch can
be enabled and disabled remotely. This is
used especially when replacing siren
battery.
z Disable the Siren tamper switch by
selecting “Siren Tamp.Off” and press
“OK”. All added sirens will
temporarity lose their Tamper
Protection simultanously
z Enable the Siren tamper switch by
selecting “Siren Tamp.On” and press
“OK”. All added sirens will be enabled
with the Tamper protection
simultanously.
<
<
N
N
O
O
T
T
E
E
>
>
) The Siren tamper disable will
automatically revert to “On” after
about an hour if not switched back.
z Confirm On, Confirm Off
Both the Outdoor Siren BX-8 can be
enabled for arming and disarming
confirmation where beeps are emitted
from the Siren to validate that the system
has been armed and disarmed.
z Disable the Siren Confirmation by
selecting “Confirmation Off” and
press “OK”.
z Enable the Siren Confirmation by
selecting “Confirmation On” and
To Next Page
Loading...