CTC-1132 868AM 2007.07.18
7
z Recording Address message
Step 1. Move the cursor to select “Rec.
Address” and then press “OK”, the
screen will ask you to confirm.
C h a n g e
A d d r e s s M s g + O k
Step 2. Press “ “ to abort. Or press “OK”
to confirm. A prompt Message will be
displayed for 2 sec.
S t a r t R e c o r d i n g
A f t e r t h e B e e p
Step 3. After 2 sec, the Control Panel will
sound a long beep, the following
prompt message will be displayed,
and recording can be started.
* N o w R e c o r d i n g *
E n d w i t h O k
Step 4. Press “OK” to end the message; the
screen will go to “Specific Part
Selection” menu to allow you to
select a specific part to be recorded.
<
<
N
N
O
O
T
T
E
E
>
>
) To end recoridng at any time, press “
“ and the message will be saved as it is.
The screen returns to “Recording
Selection” menu.
) The maximum length of Address
message is 8 sec. When the 8 sec
duration is over, recording will be
stopped automatically. The message
being recorded will be saved.
) When recording, make sure you are
facing the microphone and are within 30
cm infront of it.
z Recording Specific Alarm messages
If “Rec. Specific” is chosen, the
specific alarm message selection
menu is displayed for you to select
the desired one.
B u r g l a r M s g
F i r e M s g
P A M sg
E m e r g e n . M s g
S t o p
Selection a specific message and
follow the same procedure as those
for recording Address message to
record each specific message
respectively.
<
<
N
N
O
O
T
T
E
E
>
>
) The message length for each specific
message is 3 sec only.
z Changing a message
If for any reason, you want to change any part
of the recorded message, just follow the same
procedure to record a new message for that
part. The new message will override the
previous one.
z Test Report
Control unit allows you to test whether
telephone function is working properly or not
with the pre-set telephone numbers.
Step 1: Using “V” or ”Λ” cursors to select the
test-call number to test dial. Press
“OK” to confirm.
Step 2: Following screen will appear:
D i a l i n g . . . . . . . . .
. . . . . . . . . . . . . . . .
Step 3: Panel will show what messages are
being played. The word prompt will
shows the following:
“Now Playing:
Address Msg
Emergen. Msg
PA . Msg
Fire Msg.
Burglar Msg
The “Address Message” will be
played first. Followed by “Emergency
Message” and “Burglar Message”.
PA . Message The last “” will be
played to the recipient and to confirm
their reception & end the call by
pressing DTMF “#9”
<
<
N
N
O
O
T
T
E
E
>
>
) Messages will be played in the following
order: Address, Emergency Panic ,Fire
& Burglar message.
) Until the recipient acknowledges and
confirms acknowledgement on his or her
phone, the control unit will play the
To Next Page
Loading...