OPERATION PROCEDURE
Cooling Operation with Auto Fan Mode
Heating Operation
Heating Operation with Auto Fan Mode
Dry Operation
Temperature Selecting
This operation starts with the highest airflow in order to lower the room temperature quickly. Then it will
automatically switch to a lower airflow to maintain the set temperature.
1. Select "Heating" by pressing F (mode selection) button.
2. Press B (fan speed) button to select desired fan speed or auto fan.
3. Press H or J button to set appropriate room temperature.
This operation starts with the highest airflow in order to raise the room temperature quickly. Then it will
automatically switch to a lower airflow to maintain the selected temperature. Heating operation with auto fan
mode will automatically provide you a cold air preventive function. The fan will be turned off when temperature
of indoor heat exchanger is very low , preventing uncomfortable cold air drafts.
Select the Dry mode by pressing mode button (F). Select the suitable temperature setting. While in Dry mode,
the air conditioner will operate at low fan speed, regardless of the fan setting on the Liquid Crystal Display
(LCD) operation display. The fan will operate intermittently to prevent over cooling.
Press TEMP buttons (H) or (J) to change the temperature setting on the Liquid Crystal Display (LCD) of the
display panel. The temperature setting is shown in centigrade degrees. The number indicates room
temperature.
To Next Page
Loading...
