inlet grid
handle
filter
FM
FM
12
AUTO
C
AM
MAINTENANCE AND CARE
Cleaning the Air Conditioner
1. Cut power off before cleaning.
2. A dry soft cloth must be used for cleaning
body case
3. Avoid using organic solvent like acid and
alkali to clean the unit.
4. Avoid rinsing indoor unit with water
For the sake of safety, the unit must be turned
off and disconnected from power supply before
cleaning the equipment to avoid electricity
shock accident.
When body case is very
dirty, please soak the
cloth with warm water
below 40 and
gently wipe off the dirty
part after wresting the
cloth dry.
There are microcomputer
elements and wiring
pad in the indoor unit,
it absolutely can not
be wet and water
soaked.
Cloth must be
wrested before
cleaning.
Make sure air intake and output on the outdoor unit
are not blocked.
One of the reasons to
cause poor performance
of the unit.
Cleaning Air Filter
Whether or not to clean the air filter depends on the
instruction of the filter indicator.
Steps of removing the filter
Please make sure that the unit has terminated
operation.
Please remove the fix bolt on inlet grid.
Pull handle out in arrow direction to open the
inlet grid.
Air filter is installed on internal side of inlet grid.
and can be removed by pulling out in arrow
direction.
Cleaning Method
Please gently flick the filter or clean the filter with
electric dust collector. When there are too much
scales on the filter, to clean with warm water
modulated with neutral detergent and then clean
the detergent on the filter. Dry the filter after
cleaning and then restore its original position and
install.
Note:
Do not put the air filter under direct sun or dry it
beside stove, which will cause distortion.
Distortion may happen to filter when being
cleaned with warm water over 50
eradicator
acid
gasoline
To Next Page
Loading...
