Electro-Voice ZLX Series - Floor Monitor

ZLX Powered Loudspeaker Series Tripod, pole mount, and floor monitor operation | en 13
Electro-Voice Installation manual 2018.04 | 01 | F.01U.349.854
Mounting a loudspeaker on a pole
!
Caution!
Two person lift and placement is recommended for the heavier loudspeakers. Single person
lift and placement of heavier loudspeakers could cause injury.
To mount a loudspeaker on a pole, do the following:
1. Place the subwoofer on a level stable surface.
2. Insert the pole into the pole cup on the top of the subwoofer.
3. If you are using a threaded pole mount, turn the pole clockwise to secure the pole to the
subwoofer.
OR
If you are not using a threaded pole mount, continue to the next step.
4. Using two hands lift the loudspeaker.
5. Set the pole cup located on the bottom of the loudspeaker onto the pole.
3.2 Floor monitor
ZLX-12BT and ZLX-15BT loudspeakers may be used as a floor monitor by placing the
loudspeaker on the integral monitor angle.
Setting up as a floor monitor
To set up a loudspeaker as a floor monitor, do the following:
1. Place the loudspeaker on a level and stable surface.
2. Safely route cables to prevent injury to performers, production crew, and audience
members.
Notice!
Secure cables with wire ties or tape whenever possible.