Electro-Voice ZLX Series - Mounting and Operation Modes; Tripod and Pole Mounting

12 en | Tripod, pole mount, and floor monitor operation ZLX Powered Loudspeaker Series
2018.04 | 01 | F.01U.349.854 Installation manual Electro-Voice
3 Tripod, pole mount, and floor monitor operation
3.1 Tripod or pole mount
ZLX-12BT and ZLX-15BT loudspeakers mount on a tripod stand or on a pole above a
subwoofer.
Mounting a loudspeaker on a tripod stand
Figure3.1: Full-Range models on a tripod stand
!
Caution!
Tripod is not evaluated for safety with this loudspeaker. Check the specifications of the
tripod stand to be certain it is capable of supporting the weight of the loudspeaker.
!
Caution!
Two person lift and placement is recommended for the heavier loudspeakers. Single person
lift and placement of heavier loudspeakers could cause injury.
To mount a loudspeaker on a tripod stand, do the following:
1. Place the tripod stand on a level and stable surface.
– Fully extend the legs on the tripod stand.
– Do not compromise the tripod stands structural integrity by trying to make the stand
taller.
– Do not attempt to suspend more than one loudspeaker on a stand designed for a single
loudspeaker.
2. Using two hands lift the loudspeaker.
3. Set the pole cup located on the bottom of the loudspeaker onto the pole.