Electrolux T5675 N2 - Steam Heating Unit Service; Steam Calorifier and Damper Motor Service

Service Manual
53
10 Heating unit, steam
10.1 Replacement of steam calorifier
Disconnect the power to the machine.
Shut off the steam and demount the steam inlet and outlet hose.
Demount the two rear panels.
fig.7236A
Loosen the screws on the bracket that is holding the steam calorifier and push the bracket towards you. Carefully lift
off the steam calorifier.
Note that the steam calorifier also needs to be loosened from the mounting rail at the bottom.
fig.7237A
Mount the new steam calorifier. Tighten the screws a bit first when putting the steam calorifier in position. Loosen the
screws again and push the steam calorifier and bracket inwards as far as possible. Tighten the screws when it is in
position.
Note!
To prevent heat leakage it is important to put back the steam calorifier in correct position.