40
Procedure for use
The service program may only be
used by authorised personnel, be-
cause
most safety interlocks are
disabled.
3693
4209
Press b..four times....
... to highlight "SERVICE
PROGRAM".
Press SELECT
Press the button on the
CPU circuit board.
Prevention of unauthorised access
A button on the CPU circuit board has to be press
-
sed to gain access to the service program, to pre-
vent its unauthorised or inadvertent use. The CPU
circuit board is located behind the control panel.
Now you can choose
either to clear/reset a
register or to adjust the
weighing equipment.
If you want to exit:
Press
b repeatedly until
EXIT is highlighted.
4042 A
Press b to highlight
the option you want, then
press SELECT.
Press SELECT.
To Next Page
Loading...
