2.1 Important Information and Initial Checkout:
2.2 Review the "EDC Wiring Work Sheets":
2.3 Verify You Have all the Probes, Modules, Transducers and Cables:
2.4 Install the MVP Display:
2.5 Install the Temperature Probes:
2.6 Install the Pressure Transducers:
2.7 Install the Interface Circuit for Annunciators:
2.8 Install the Interface Circuit for Flap and Trim Pots:
2.9 Install the Interface Circuit for the Gear Position, Unsafe Indicator and Gear
Warning:
2.10 Install the CO Guardian CO Detector:
2.11 Install the Shunt:
2.12 Install the Fuel Flow Transducer:
2.13 Install the P-300C Fuel Level Probes:
2.14 Install the P-300M Magnetic Fuel Level Sender:
2.15 Install the Resistive Fuel Level Module (RFLM-4-X):
2.16 Install the Voice Alarm Control Panel:
2.17 Install the Intensity Control Pot (CP-1):
2.18 Install the Master Warning (red) and Caution (yellow) Lights:
2.19 Install the USB-6A:
2.20 Install the FM-SC or AC-1 Converter:
2.21 Install the BC-5xx:
2.22 Installing the NA-1:
2.23 Installing any Additional Modules:
2.24 Installing the EDC-33T:
2.0 HARDWARE INSTALLATION
7
To Next Page
Loading...
Need help?
General
