Automatic Resin Feeding and Automatic Resin Recycle FAQ
No.1 Automatic resin feeding does not take effect during printing
1. Check whether the automatic resin feeding function is enabled by default;
2. Check whether the USB interface is plugged in properly, and re-plug the installation module.
If the green indicator light is always on, it is normal;
3. Check whether the probes are mistakenly connected. When the resin liquid level is lower than
the probe, the red indicator light should be on.
No.2 There is enough resin in the resin bottle, but the pop-up window shows
that the resin bottle is empty
1. The signal detection terminal is not inserted;
2. The screw fixing the signal line on the bottle cap is loose.
No.3 The resin in the resin tank is sufficient, but the device continues to add
resin
1. It is not installed in place, causing the probe is not correctly extended into the resin tank, and
re-install according to the installation steps in the instructions;
2. After the resin in the resin tank has passed through the probe, the red indicator light does not
turn off. This device does not support the use of this resin. Replace other resins and test again.
No.4 The automatic resin recycle function is turned on, but the resin cannot
be recycled
1. Check whether the USB interface is plugged in properly, re-plug the installation module, if the
green indicator light is always on, it is normal;
2. The signal detection terminal is not inserted;
3. The screw fixing the signal line on the bottle cap is loose.
No.5 The resin bottle is full, but the resin continues to be recycled
1. The signal detection terminal is not inserted;
2. This device does not support the use of this resin, replace other resins and test again.
To Next Page
Loading...
