36
English
9.6.3. While working
Caution: Always wear personal protective equipment. (Safety goggles, gloves,
hearing protectors, safety footwear, etc.)
• Be very attentive while working. While operating the machine, you must focus all of your at-
tention on it.
• Start the engine.
(see Section 9.4, page 29)
• Allow the machine to run empty for at least 5 minutes so that it heats up.
For your information: When shredding at temperatures around freezing, you
will have to ensure that you are shredding branches with a maximum diameter
of 50 mm - 2”.
For your information: Always shred at full throttle. This will ensure optimal
performance.
9.6.4. Operating the feed roller
In order to simplify operating the feed roller, we have opted for a clear and comprehensible
system that requires you to move the handle, as depicted below.
• Pulling on the handle (see the image below) will cause the feed roller to start moving, drawing
the material to be shredded into the feeding hopper at a constant speed. If you push the handle
forward once, the feed roller will stop. If you push on the handle a second time, the feed roller
will move in the opposite direction and move the material out of the feed hopper.
• The feeding position (IN) is a fixed position.
• The stop position of the feed roller (STOP) is also a fixed position.
• The backflow position (OUT) is a variable position. The handle will automatically return to the
stop position. In order to continue the backflow of material, you will need to continuously push
on the handle.
To Next Page
Loading...
