74
English
11.5.8.14. Lubricating the bearings
This group includes the following locations on the machine:
Blade shaft bearings.
Use the following procedure:
• Spray some penetrating oil containing molyb-
denum disulphide onto the bearing and the
area around it, and allow the oil to penetrate.
• Wipe away any dirt stuck to the outside of the
bearing.
• Spray more penetrating oil into the bearing
joints.
• Turn the bearing. You could even start up the
mechanism that turns the bearing (Caution:
Make sure that all dangerous areas are adequa-
tely shielded).
• Wipe away any dirt that is forced out by the
penetrating oil.
• Use compressed air to remove excess penetra-
ting oil from the bearing and the bearing joints.
• Apply new lubricating oil. ELIET recommends Novatio Clear Lube as a lubricant.
• Wipe away any excess lubricant.
To Next Page
Loading...
