44
English
10. Transporting the machine
• Make sure the machine is properly secured to the vehicle during transport. Use the 4 eyelets
along the side of the frame (2 each side) to attach the straps or ropes.
• It is very important that the infeed opening is completely free of branches and material.
• Before loading the Prof 6 onto a trailer or into a van, the
blow chute may be lowered to accommodate the vehicle's
height. Use the following procedure: See “11.3.5. Setting the
blow chute to the working or lowered position”, page 54.
• If you are stepping up onto a trailer, ensure that it is secu-
rely attached to the leading vehicle.
• Use slip-resistant ramps to load the machine into a van or
trailer. Ensure that they have been properly attached to the
vehicle or the trailer, and that the vehicle's hand brake has
also been set.
• The maximum degree of lateral slope authorised for the shredder is 10%.
• Under no circumstances should the angle of the ramps going up or down exceed 20%.
• When loading and unloading the machine, turn on the engine, and remain careful and wariness,
so that the machine does not tip over and cause an accident.
• When coming down a ramp, descend backwards while facing the machine. See “9.5. Moving the
machine”, page 31.
• If gravity causes the machine to descend more quickly down the slope than is desired, quickly
move the control handle in the other direction. This activates the hydraulic brake on the ma-
chine.
To Next Page
Loading...
