60
English
When replacing the filter, also change the hydraulic fluid. See “11.4.6. Refilling the hydraulic fluid”,
page 58.
The filter cartridge includes a central filter which is screwed into the cartridge fixture.
Unscrew the filter cartridge by turning it counter-clockwise.
Completely unscrew the cartridge and allow the remaining fluid to flow through the funnel. -Wipe
away the fluid and also clean the filter cartridge fixture.
New filter cartridges are always obtainable from your authorised ELIET dealer. Order code: BH
280 212 010
• Soak the new filter's gasket in hydraulic fluid to moisten it.
• Now screw the new filter cartridge onto the fixture by hand.
• Once the cartridge has been attached to the fixture, make a further
3/4
turn to ensure that the
seal is tight.
• Fill the hydraulic oil tank and replace the cap.
• Start the engine and engage the starter to circulate the fluid and warm up the machine.
• Ensure that the entire fluid circuit is well sealed (no leaks)
• Clean any fluid that has spilled with paper, and dispose of wet cloths as chemical waste.
• The filter cartridge will also be disposed of as chemical waste.
To Next Page
Loading...
