1. Make sure that all equipments which must be kept far away from
water are kept dry. If the water enters into the product, please turn
off the power supply and then contact with your provider for
assistance.
2. Only use the original cables supplied with the robot. Do not use
the robot in applications where the cables are subjected to flexing.
If a longer cable or a flexible cable is needed, contact your provider.
3. A negative connector is defined as the Ground (GND) connector
which is connected to a shield of the robot and the control box. All
GND connectors mentioned in the text are only suitable for
powering and transmitting signals. For protective earth (PE),
please provide the control box with the reliable GND with the
dedicated power supply socket of the control box.
4. Please be careful when installing the interface cable to the robot
I/O. A metal plate on the back of the box is intended for the
interface cables and connectors. Please remove the metal plate
before drilling holes. Make sure that all matte sides are removed
before reinstalling the metal plate. Remember to use the correct
size gland.
Caution:
1. The robot has been tested in accordance with international IEC
standards for electromagnetic compatibility (EMC). Disturbing
signals with levels higher than those defined in the IEC standards
may cause unexpected behaviors of the robot. Very high signal level
or excessive exposure may damage the robot permanently. The EMC
problems happen usually during welding and are usually prompted
by the error messages in the log. ELITE shall not be held responsible
for any damages caused by EMC problem.
To Next Page
Loading...