ELTEX MES1000 User Manual

112 MES1000, MES2000 Ethernet Switches
Ethernet interface configuration mode commands
Command line request in Ethernet interface, port group interface configuration mode appears as
follows:
console(config-if)#
Table 5.109 —Ethernet interface configuration mode commands
Command
Value/Default value
Action
ethernet cfm mep id
domain domain_name
service { vlan-id vlan_id |
name name |
number number }
id: (1..8191)
domain_name: (0..32)
characters
vlan_id: (1..4094)
name: (0..45) characters
number: (0..65535)
Create maintenance end point (MEP) on the interface with 'id'
identifier for the selected maintenance in the specified
domain and enter the MEP configuration mode.
no ethernet cfm mep id
domain domain_name
service { vlan-id vlan_id |
name name |
number number }
Remove maintenance end point (MEP) from the interface.
Maintenance end point configuration mode commands
Command line request in domain configuration mode appears as follows:
console(config-if-cfm-mep)#
Table 5.110 —CFM end point (MEP) configuration mode commands
Command
Value/Default value
Action
active
-/disabled
Disable maintenance end point (MEP).
no active
Set the default value.
continuty-check enable
-/disabled
Enable Continuty Check message transmission.
no continuty-check enable
Set the default value.
cos cos
cos: (0..7)/7
Set CoS priority value for transmission of Continuty Check
messages.
no cos
Set the default value.
alarm delay delay
delay: (2500..10000)
ms/2500 ms
Define the delay interval that should pass before the alarm
generation.
no alarm delay
Set the default value.
alarm reset interval
interval: (2500..10000)
ms/10000 ms
Define the time interval that should pass before the alarm
reset.
no alarm reset
Set the default value.
alarm notification { all |
error-xcon | remote-error-
xcon | mac-remote-error-
xcon | xcon | none }
-/mac-remote-error-xcon
Enable notifications for the specific event types.
Event types:
- all—all DefRDI, DefMACStatus, DefRemote, DefError,
DefXcon events
- error-xcon—DefError and DefXcon events only
- remote-error-xcon—DefRemote, DefError, and DefXcon
events only
- mac-remote-error-xcon—DefMACStatus, DefRemote,
DefError, and DefXcon events only
- xcon—DefXcon event only
- none—notifications disabled
no alarm notification
Set the default value.
Privileged EXEC mode commands
Command line request in privileged EXEC mode appears as follows:
console#
Table 5.111 —Privileged EXEC mode commands
Command
Value/Default value
Action
show ethernet cfm domain
[name]
name: (1..32) characters
Show information on the specific domain or all domains.

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English