ELTEX MES1000 User Manual

MES1000, MES2000 Ethernet Switches 111
console(config-cfm-md)#
Table 5.107 —CFM domain (MD) configuration mode commands
Command
Value/Default value
Action
id { dns dns | name name |
id mac mac_address
number | id null }
name: (1..43) characters
dns: (1..43) characters
mac_address: H.H.H or
H:H:H:H:H:H or H-H-H-H-H-
H
number: (0-65535)
By default: id name
matches the domain name
Specify CFM domain (MD) identifier. Possible domain names:
- dns—dns name
- name—text string
- mac_address number—MAC address and domain numeric
identifier
- null—NULL identifier
no id
Set the default value.
service port { vlan-id
vlan_id | name name |
number number }
vlan: (1..4094)
vlan_id: (1..4094)
name: (1..45) characters
number: (0..65535)
Create CFM maintenance (MA) without VLAN association and
enter the maintenance configuration mode.
no service port
Remove CFM maintenance (MA).
service vlan vlan { vlan-id
vlan_id | name name |
number number
Create CFM maintenance (MA) associated with VLAN (with
'vlan' number) and enter the maintenance configuration
mode. Possible service names:
- vlan_id—VLAN number
- name—text string
- number—numeric identifier
no service vlan vlan_id }
Remove CFM maintenance (MA) associated with VLAN (with
'vlan' number).
mip auto-create [lower-
mep-only]
-/automatic creation is
disabled
Enable automatic creation of maintenance intermediate
points (MIP). Maintenance intermediate points (MIP) created
on all ports, where VLAN maintenance is defined.
Optional parameter 'lower-mep-only' allows to exclude ports,
where maintenance end point is created.
no mip auto-create
Restore the default value.
Maintenance configuration mode commands
Command line request in domain configuration mode appears as follows:
console(config-cfm-ma)#
Table 5.108 —CFM maintenance (MA) configuration mode commands
Command
Value/Default value
Action
continuty-check interval
interval
interval: (1, 10, 100, 600)
seconds/1 second
Set the Continuty Check message sending interval.
no continuty-check interval
Set the default value.
direction down
-
Set the downstream direction for the maintenance end point
(MEP).
no direction down
Set the upstream direction for the maintenance end point
(MEP).
mep id
id: (1..8191)
Add the maintenance end point (MEP) with 'id' identifier to
this maintenance.
This command performs MEP association with the
maintenance only. MEP is created in the interface
configuration mode.
no mep id
Remove maintenance end point (MEP).
mip auto-create [ { lower-
mep-only | none } ]
-/The mode, configured for
domain with existing
maintenance, is used by
default
Enable automatic creation of maintenance intermediate
points (MIP). Maintenance intermediate points (MIP) created
on all ports, where VLAN maintenance is defined. Optional
parameters:
- lower-mep-only—allows to exclude ports, where
maintenance end point is created
- none—disable automatic creation of maintenance
intermediate points (MIP)
no mip auto-create
Set the default value.

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English