ELTEX MES1000

128 MES1000, MES2000 Ethernet Switches
authorization cache-
timeout timeout
minutes/0
counter is disabled (the record will not be deleted in time).
no ip igmp snooping
authorization cache-
timeout
Set the default value.
Ethernet interface configuration mode commands (interface range)
Command line request in interface configuration mode appears as follows:
console(config-if)#
Table 5.133 —Ethernet interface configuration mode commands
Command
Value/Default value
Action
multicast snooping
authorization radius [required]
-/disabled
Enable authorization via RADIUS server. If the required
parameter is specified, IGMP queries will be ignored when all
RADIUS servers are unavailable.
Otherwise, IGMP query will be processed even when there is
no reply from the server.
no multicast snooping
authorization
Disable the authorization.
multicast snooping
authorization forwarding-first
-/disabled
Enable IGMP query pre-processing for port before the reply is
received from RADIUS server. When the server reply is
received, the subscription retains, if the answer is positive, or
is deleted, if the answer is negative.
no multicast snooping
authorization forwarding-first
Restore the default value.
EXEC mode commands
All commands are available to the privileged user only.
Command line request in EXEC mode appears as follows:
console#
Table 5.134 —EXEC mode commands
Command
Value
Action
show ip igmp snooping
authorization-cache
[gigabitethernet gi_port |
fastethernet fa_port ]
gi_port: {1..3/0/1..28};
fa_port: {1..3/0/1..24};
Show IGMP authorization cache contents.
If the interface is defined in the command, device will show
only groups registered on that interface.
clear ip igmp snooping
authorization-cache
[gigabitethernet gi_port |
fastethernet fa_port ]
gi_port: {1..3/0/1..28};
fa_port: {1..3/0/1..24};
Clear the authorization cache.
If the interface is defined in the command, cache records will
be cleared for that interface.
In the interface is not defined, the entire cache will be
cleared.