ELTEX MES1000

184 MES1000, MES2000 Ethernet Switches
ip source-guard tcam
retries-freq {seconds |
never}
(10..600, never)/60
seconds
Specify the device access rate to internal resources for storing
the inactive secured IP addresses into the memory.
- never—deny storing the inactive secured IP addresses into
the memory
no ip source-guard tcam
retries-freq
Restore the default value.
Ethernet interface configuration mode commands (interface range), port group interface
Command line request in Ethernet interface, port group interface configuration mode appears as
follows:
console(config-if)#
Table 5.216 —Ethernet interface configuration mode commands, interface group
Command
Value
Action
ip source-guard
Function is disabled by
default.
Enable client IP address protection function for the configured
interface.
no ip source-guard
Disable client IP address protection function for the configured
interface.
Privileged EXEC mode commands
Command line request in Privileged EXEC mode appears as follows:
console#
Table 5.217 —Privileged EXEC mode commands
Command
Value
Action
ip source-guard tcam locate
–
Manually start the access to internal resources for storing the
inactive secured IP addresses into the memory. This command
is available to privileged users only.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console#
Table 5.218 —EXEC mode commands
Command
Value
Action
show ip source-guard
configuration
[gigabitethernet gi_port |
fastethernet fa_port | port-
channel group]
gi_port: (1..3/0/1..28);
fa_port: (1..3/0/1..24);
group: (1..8)
Command shows IP address protection function configuration
for the selected (or all) device interfaces.
show ip source-guard status
[mac-address mac_address]
[ip-address ip_address ]
[vlan vlan_id]
[gigabitethernet gi_port |
fastethernet fa_port | port-
channel group]
gi_port: (1..3/0/1..28);
fa_port: (1..3/0/1..24);
vlan_id: (1..4094);
group: (1..8)
Command shows the status of IP address protection function,
IP address, MAC address, and VLAN group.
show ip source-guard
inactive
-
Command shows inactive sender IP addresses.
Example execution of commands