ELTEX MES1000 User Manual

MES1000, MES2000 Ethernet Switches 229
B_RS
Control of device reboot in stack
TRMT
Control of units in stack with transactions support
SW2M
Processing events Address update from FDB, blockage of port in case of faults on the
port
exRX
Processing of packages output from lower level 2
3SMA
Ageing for ip multicast
3SWF
Transfer of packages between level 2 and network level
3SWQ
Program processing of intercepted packages ACL
POLI
Policy Management
NTST
Addition and removal of units in stack, reset to default status of unit on network
level
NTPL
Periodic generation of signal for scanning tables of MAC, VLAN, ports, multicast,
routing, prioritization
L2HU
Transfer of packages to level 3
L2PS
Processing of events of status/interface configuration change and transfer messages
to registered services
LBDR
Configuration and receipt of Loopback Detection packages
LBDT
Sending Loopback Detection packages
SFSM
Processing sFlow
NSCT
Configuration of packages interception rate on CPU, maintenance of statistics for
intercepted packages
BRGS
Brige security - arp inspection, dhcp snooping, dhcp relay agent, ip source guard,
pppoe intermediate agent
FFTT
Management of routing table and routing of packages
KEYM
Management of authentication keys
IPAT
Management of IP addresses database
IP6C
Counters ipv4 and ipv6
IP6M
ipv4 and ipv6 routing
RPTS
Routing protocol
ARPG
Realization of ARP protocol
IPG
Processing of intercepted fragmented IP packages
ICMP
Realization of ICMP protocol
TFTP
Realization of TFTP protocol
IPRD
Supplementary task for ARP, RIP, OSPF
DNSC
DNS client
PNGA
Ping realization
UDPR
UDP relay
TRCE
Trace route realization
SSLP
Realization of SSL

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English