MES1000, MES2000 Ethernet Switches 41
Setting Password for HTTP
To configure the password for access via HTTP protocol, enter the following commands:
console(config)# ip http authentication local
console(config)# username admin password passwd4 level 15
During the HTTP session initialization, enter the username admin and the password passwd4.
Device Access Password Recovery.
For default device settings, username is admin, password is not assigned. Password should be
assigned by the user. If the password is lost, you can restart the device and interrupt its startup via the
console port by pressing <Esc> or <Enter> keys in two seconds after the automatic startup message is
displayed. The Startup menu will open, where you can initiate the password recovery procedure ([3]
Password Recovery Procedure).
To Next Page
Loading...
Need help?
General
