EasyManuals Logo

EMC CLARiiON DAE2P User Manual

EMC CLARiiON DAE2P
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
3-20
DAE2P/DAE3P Hardware Reference
Servicing a DAE2P/DAE3P
Replacing a power supply/system cooling module
CAUTION
!
Handle a power supply/system cooling (power/cooling) module
gently and use an ESD wristband. Do not remove a power/cooling
module until you have a replacement module available.
Access to the disks in your enclosure will time out and the disks
will spin down two minutes after a power/cooling module is
removed from the enclosure. While the system can continue
operating on a single power supply, the loss of a module’s two
blowers will cause a time-out unless you replace the module within
two minutes.
When replacing a power/cooling module, make certain the green
LED on one module has been steadily on for at least 5 seconds
before removing power from the second module.
Follow these steps to replace a power/cooling module.
1. Unplug the AC line cord as shown in Figure 3-15.
Figure 3-15 Unplugging the AC power cord
2. Turn the captive screw counterclockwise to release the module,
and then remove the power/cooling module as shown in
Figure 3-16.
!!
!!
!
EXPPRI
EXP
PRI
#
!
EXP PRI
EXP
PRI
#
A
B
EMCrempwr
Retention Bail
Retention
Bail

Table of Contents

Other manuals for EMC CLARiiON DAE2P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EMC CLARiiON DAE2P and is the answer not in the manual?

EMC CLARiiON DAE2P Specifications

General IconGeneral
BrandEMC
ModelCLARiiON DAE2P
CategoryEnclosure
LanguageEnglish

Related product manuals