EMC HD400 - Disassembly Details; Required Tools for Disassembly; Safety Precautions

28
WEEE Disassembly Instructions for the
HD400 Disk Processor Enclosure
12.0 Disassembly Details
The following sections describe how to remove the components and associated materials.
12.0.1 Required Tools for Disassembly
Table 15 lists the tools that may be required to disassemble the product.
Table 15 Tools
12.0.2 Safety Precautions
Comply with the following precautions:
 Wear protective glasses during disassembly.
 Follow the recommended disassembly method and sequence.
 Always use the tool specified in the removal procedures.
 Follow standard industry best practices, including all applicable health and safety regulations.
Tool
Description
Phillips screwdriver
#1
Phillips screwdriver
#2
Flat-head screwdriver
Small
Needle-nose pliers
Use to remove precise hardware from PCBs.
Tork Screwdriver
Use to remove T8 size screws.
Wire Cutters
Use to remove capacitors, or cut wires.
Soldering Iron
Use to unsolder the leads that attach some
components to a PCB.