EMC HD400 - Removing the Power Supplies

37
WEEE Disassembly Instructions for the
HD400 Disk Processor Enclosure
2. Remove four screws to remove the fan grills from the Fans and remove the grills.
3. Cut the wires to the fans from the power connector.
4. Slide the power connector to the right and remove it from the fan chassis.
5. The fan module can now be recycled.
12.0.3.4 Removing the Power Supplies
1.
From the rear of the node, locate the power supply to be replaced.
2.
While pressing the orange release tab to the left, grab the handle on the power supply and
pull it from the rear of the node.