EMC HD400 - Disassembling the Chassis to Retrieve the Base Board PCB

58
WEEE Disassembly Instructions for the
HD400 Disk Processor Enclosure
12.0.3.6 Disassembling the Chassis to Retrieve the Base Board PCB
To disassemble the 60-slot chassis:
1. Remove all components listed in 15.0 disassembling the HD400 Disk Processor Enclosure.
Note: All materials that make up the chassis are ready for recycling after all components are
removed.
2. Remove the two flanges (or brackets) on either side of the chassis.
Figure 4. Locating a flange
3. Remove the top cover from the chassis.