EMC HD400 - Removing the Front Panel

33
WEEE Disassembly Instructions for the
HD400 Disk Processor Enclosure
12.0.3.2 Removing the Front Panel
1. Pull forward on the orange tab to release the Front Panel latching tab.
2. While holding the tab forward, slide the Front Panel to the right so that the keyholes on the
mounting plate are aligned with the heads of the mounting screws.
3. Carefully pull the Front Panel forward and gently lay the assembly down to access the
ribbon cable on the rear of the Front Panel.
4. Disconnect the ribbon cable from the connector on the chassis.
5. Remove the Front Panel.
12.0.3.3 Disassembling the Front Panel Assembly