48
WEEE Disassembly Instructions for the
HD400 Disk Processor Enclosure
d. Disconnect the black and yellow cable power cable from the Boot Drive Carrier Card.
7. Remove the Battery Pack as follows:
a. Disconnect the two cables from the Battery Pack connectors.
b. Pull out the orange tab to release the Battery Pack. Make sure the retaining tab is clear of the
mounting hole in the side of the suitcase.
c. While holding the orange tab out, use the other hand to slide the Battery Pack to the front of the
suitcase to align the mounting screws with the mouse holes.
d. Remove the Battery Pack by pulling it away from the chassis.
e. Disassemble the Battery Pack as follows:
i. Remove one screw securing the Battery Pack Cover and remove the cover by
sliding it to the left to free the retaining tabs. .
ii. Cut the wires from each battery.
To Next Page
Loading...