Emerson 1410 Reference Manual

3
Reference Manual
00809-0200-4410, Rev BC
Initial Connection
July 2017
Initial Connection
Section 2 Initial Connection
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3
System requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4
Initial connection and configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4
2.1 Overview
This section describes how to connect to the Gateway for the first time and what settings should be
configured before placing it on a live control network. It is important to note that some Gateways are
used in stand-alone applications and do not reside on a network. In these cases, it is still important to
configure the items outlined in this section.
Before the Gateway can be permanently mounted and connected to a live control network, it needs to
be configured with an IP address. This is done by forming a private network between the Gateway and a
PC/laptop. The following items are required to complete this section:
 Gateway
 PC/laptop
 Ethernet Cable
 24 VDC (nominal) power supply
Failure to follow these installation guidelines could result in death or serious injury.
 Only qualified personnel should perform the installation.
Explosions could result in death or serious injury.
 Verify the operating atmosphere of the gateway is consistent with the appropriate hazardous
locations certifications.
 Do not make or break connections to the Emerson
™
1410 Wireless Gateway (Gateway) while circuits
are live unless the area is know to be non-hazardous.
 Potential electrostatic charging hazard. Enclosure is a polymer, use care when handling or cleaning.
Electrical shock could cause death or serious injury.
 Use extreme caution when making contact with the leads and terminals
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions:
 This device may not cause harmful interference.
 This device must accept any interference received, including interference that may cause undesired
operation.
 This device must be installed to ensure a minimum antenna separation distance of 20 cm from all
persons.

Emerson 1410 Specifications

General

Brand	Emerson
Model	1410
Category	Gateway
Language	English