15
Reference Manual
00809-0200-4410, Rev BC
Mounting and Connection
July 2017
Installation
Note
Do not mount the antenna within a metal enclosure. To avoid damage to sensitive RF components, do
not remove protective cap from the Gateway SMA connector until ready to install the antenna.
3.3 Remote antenna
The small black flexible basic antenna supplied with the unit is for bench testing. In most locations, a
remote antenna is recommended for best range and performance. The remote antenna options provide
flexibility for mounting the Gateway based on wireless connectivity, lightning protection, and current
work practices.
Note
To avoid damage to sensitive RF components do not remove protective cap from the Gateway SMA
connector until ready to install the antenna.
The remote antenna kit includes coaxial sealant for the cable connections, for the lightning arrestor, and
for the antenna.
Find a location where the remote antenna has optimal wireless performance. Ideally this will be 15–25 ft
(4,6–7,6 m) above the ground or 6 ft (2 m) above obstructions or major infrastructure. To install the
remote antenna use one of the following procedures:
When mounting the unit in an electrical enclosure or other location, comply with the appropriate local
and governmental installation codes. Verify the installer, associated hardware, and installation
equipment used have the proper certifications for the specific type of installation being performed.
Before installation, verify if local codes require a permit and/or an inspection before energizing. When
planning the installation, account for routing the antenna cable within the enclosure.
When installing remote mount antennas for the Wireless Gateway, always use established safety
procedures to avoid falling or contact with high-power electrical lines.
Install remote antenna components for the Wireless Gateway in compliance with local and national
electrical codes and use best practices for lightning protection.
Before installing consult with the local area electrical inspector, electrical officer, and work area
supervisor.
The Wireless Gateway remote antenna option is specifically engineered to provide installation flexibility
while optimizing wireless performance and local spectrum approvals. To maintain wireless
performance and avoid non-compliance with spectrum regulations, do not change the length of cable
or the antenna type.
If the supplied remote mount antenna kit is not installed per these instructions, Emerson is not
responsible for wireless performance or non-compliance with spectrum regulations.
To Next Page
Loading...
