35
Reference Manual
00809-0200-4410, Rev BC
Host Integration
July 2017
Host Integration
5.5 EtherNet/IP
Communication settings
It is important that the EtherNet/IP communication settings in the Gateway match the setting in the
EtherNet/IP master or client. Refer to the host system documentation for more information on how to
configure these settings, or to the Emerson Wireless Integration Manual
for the EtherNet/IP. The
EtherNet/IP communication settings can be found by navigating to System Settings>Protocols>Ethernet/IP.
Note
EtherNet/IP can be integrated with any approved EtherNet/IP ODVA member. Other protocols such as
HART-IP
™
are still functional within the Gateway. Refer to Emerson Wireless Gateway Product Data Sheet
for ordering options.
SYSTEM_DIAG.TEST_UNSIGNED_SHORT 49035 16-bit unsigned int
SYSTEM_DIAG.TEST_INT 49036 32-bit int
SYSTEM_DIAG.TEST_UNSIGNED_INT 49038 32-bit unsigned int
SYSTEM_DIAG.TEST_FLOAT 49040 32-bit float
Table 5-2. Predefined Modbus Registers
Description Register Data type
To Next Page
Loading...
