EasyManua.ls Logo

Emerson Damcos - February 2017 SM 8000-100-01 Ed

Emerson Damcos
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service Manual Damcos LPU: Table of Contents
SM 8000-100-01 Ed 04 February 2017
4
Noise from pump, but only at high pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
Noise from pump at both high and low pressure. . . . . . . . . . . . . . . . . . . . . . . . 55
Motor running hot, LPU is operating normally . . . . . . . . . . . . . . . . . . . . . . . . . . 56
LPU-D not maintaining pressure on actuator . . . . . . . . . . . . . . . . . . . . . . . . . . . 57
Spring actuator only partly closing or not starting to close . . . . . . . . . . . . . . . 58
Emergency operation by key giving oil spillage through breather valve . . . . 59
Emergency operation by key not possible, hydraulically locked. . . . . . . . . . . 59
Emergency operation by hand pump giving oil spillage through breather valve
59
Emergency operation by hand pump not possible . . . . . . . . . . . . . . . . . . . . . . 60
Pump not rendering sufficient oil at high pressure (“valve running too slowly”)
61
Pump not rendering sufficient oil at low pressure (“valve running too slowly”)
61
Motor running for a short time and stops
High pressure on the port to which oil is led. . . . . . . . . . . . . . . . . . . . . . . . . . . . 62
Motor running for a short time and stops . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62
Motor ”diving” in RPM in end position . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63
Motor ”diving” in RPM as spring actuator opens . . . . . . . . . . . . . . . . . . . . . . . . 63
Oil spillage, generally . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64
Oil in electronic connection box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64
Oil spillage from breather valve. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64
Unit drawing too much current. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65
Too little tank volume for operating actuator . . . . . . . . . . . . . . . . . . . . . . . . . . 66
LPU cannot raise pressure after hand pump operation
(but no problems after remote operation) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 67
LPU leaking from bleeder valve when hand pump is mounted . . . . . . . . . . . . 68
Spring actuator do not close by emergency hand pump operation. . . . . . . . 69
LPU-Ex motor do not run . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70
LPU-Ex has to be bulkhead mounted because of too little space or zone 0 at ac-
tuator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 71
Position indicator errors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 72
Operating LPU-S 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73
Operating LPU-D 2a . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75
Emergency Operation of LPU V.2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77
Speed adjustment for Actuator on LPU (v.2) . . . . . . . . . . . . . . . . . . . . . . 83
Pump pressure adjustment for LPU . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85

Table of Contents

Related product manuals