Damcos LPU: Speed adjustment for Actuator on LPU (v.2) Service Manual
February 2017 SM 8000-100-01 Ed 04
83
Speed adjustment for Actuator on LPU (v.2)
Speed adjustment for double acting actuators
Speed will be adjusted by means of a 3 mm Allen key, see picture below where to adjust. By turning
the screw clockwise (fasten screw), the actuator will run slower, turning the screw counterclockwise
it runs faster. If the actuator has to run with maximum or minimum speed, the adjustment screw
shall only be tightened slightly (max 1.5 Nm).
Speed adjustment for single acting actuators
Opening and closing speed will be adjusted by means of a 3 mm Allen key, see picture below where
to adjust. By turning the screw clockwise (fasten screw), the actuator will run slower, turning the
screw counterclockwise it runs faster. If the actuator has to run with maximum or minimum speed,
the adjustment screw shall only be tightened slightly (max 1.5 Nm).
To Next Page
Loading...
