Damcos LPU: Setup new P-net LPU circuit board Service Manual
February 2017 SM 8000-100-01 Ed 04
101
Setup new P-net LPU circuit board
Warning! Disconnect the power before changing the circuit board!
Replace Circuit Board in LPU
1. Replace the P-net LPU circuit board. See “Replace
Printed Circuit Board” on page 105.
Write down the S/N of the new circuit board.
2. Go to the computer and switch to Project 3.10
using the keyboard; press ALT and TAB and then
select Project 3.10.
The window as of point 3 below should be opened.
3.
To Next Page
Loading...
