3410 Series Gas Ultrasonic Meters Operations Manual Section 5: Calibrate and configure the meter
3-9000-777 Rev E January 2018
Triggered Delta Volumes 51
Gas Chromatograph setup (Section 5.11)
Configure a serial port as a Modbus master for polling a GC. Selections include:
• Serial port
• GC protocol
• GC baud rate
• GC comms address
• GC stream number
• GC heating value units
• GC heating value type
• Gas composition to use on alarm
AGA8 calculations
(Section 5.12)
Configure the properties necessary for the AGA8 calculations. Selections
include:
• Gross Method 1
• Gross Method 2
• Detail
• Externally
Continuous flow analysis
(Section 5.13)
Configure the Continuous Flow Analysis features. Selections include:
• Flow limits
• SOS comparison
• Liquid detection
• Abnormal profile
• Blockage
• Internal bore buildup
Local Display
(Section 5.14)
Configure the local display settings. Selections include:
• Display units
• Display Items
• Scroll Delay
Table 5-5 Configure operational parameters
Calibration selection Description
To Next Page