Emerson Daniel 3415

NOTICE
Prior to lifting the unit, refer to the Daniel 3415, 3416, or 3417 Gas Ultrasonic Flow Meter
nameplate or outline dimensional (general arrangement) drawing for the assembled weight.
WARNING!
FLUID CONTENTS MAY BE UNDER PRESSURE
When the meter is under pressure, DO NOT attempt to remove or adjust the transducer holder.
Attempting to do so may release pressurized gas or fluid, resulting in serious injury or
equipment damage.
WARNING!
CONTENTS MAY BE HAZARDOUS
The meter must be fully depressurized and drained before attempting to remove the
transducer holder. If gas or fluid begins to leak from the transducer holder, stop immediately
and reinstall the holder.
Failure to comply may cause serious injury or equipment damage.
A. Transducer holder
CAUTION!
ESCAPING GASES OR FLUIDS HAZARD
The purchaser of the meter is responsible for the selection of Daniel components/seals and
materials compatible with the chemical properties of gas flow measurement.
Failure to select the suitable meter component/seals may cause escaping gases or liquids,
resulting in injury or equipment damage.
Meter repairs
14 Gas Ultrasonic Flow Meter