Emerson EIM 2000 Series - Introduction to EIM 2000 Series M2 CP Digital Futronic

March 2013
User Manual
84829 Rev. D
Introduction
Section 1: Introduction
The Digital Futronic module uses the latest integrated microcontroller technology to
enable one electronics module to perform valve actuator modulating and positioning
control from analog control signals. The control module uses EIM’s M2CP TBM01
termination panel for interface of all analog control types. The Digital Futronic module
converts 4-20mA analog input to digital for processing and from digital to 4-20mA analog
output for position feedback. The Digital Futronic module controls three EIM motor
control starter types.
1. Futronic II Electro-mechanical AC motor starter
2. Futronic III SCR Solid-state DC motor starter
3. Futronic IV Triac Solid-state (SSR) AC motor starter
1
Section 1: Introduction