Emerson EIM 2000 Series - Module Setup Options

User Manual
84829 Rev. D March 2013
Module Setup and Calibration
4�2 Setup
4.2.1 Normal Run Mode (S1, S2, S3 OFF)
Turn off S1, S2 & S3 for Normal Run Mode - Figure 3.
Figure 3
4.2.2 Cal Analog Input (S1 ON)
Press UP to set Span (20mA) Input - Figure 4.
Press DOWN button to set Zero (4mA) Input - Figure 4.
Figure 4
4.2.3 Cal Analog Output Zero (S2 ON)
Press UP to increase (4mA) Output - Figure 5.
Press DOWN to decrease (4mA) Output - Figure 5.
Figure 5
4.2.4 Cal Analog Output Span (S3 ON)
Press UP to increase (20mA) Output - Figure 6.
Press DOWN to decrease (20mA) Output - FIgure 6.
Figure 6
6
Section 4: Module Setup and Calibration