March 2013
User Manual
84829 Rev. D
Module Setup and Calibration
Section 4: Module Setup and Calibration
DIP Switch SW3 has 6 switches designated as S1-S6 for calibration and mode selection as
summarized below. There are two push buttons labeled UP and DOWN.
Refer to Figure 2 for location of DIP switches and push buttons.
Figure 2
4�1 Indicator Lights
4.1.1 LED 1
• Slow Flash = Normal Operating Mode.
• Rapid Flash = Setup mode (any one of switches S1 through S3 are on).
• Alternating Between Slow and Rapid Flash = Lost Analog Input (Command) Signal.
• Steady On or Steady Off = Module failure.
4.1.2 LED 2
• On when Solid State Relay (SSR or SCR) is On (control power applied to output).
5
Section 4: Module Setup and Calibration
To Next Page
Loading...
