Emerson EL-O-Matic F Series - 8.4 Removing of Limit Stop screws; 8.5 Removing Pistons

Disassem bly
8.4 Removing of Limit Stop screws
1. Remove the limit stop screws (30), limit stop nuts (31), limit stop washers (32) and
limit stop o-rings (33). Discard the o-rings.
Figure 23 Limit Stop Removal
33 30
31
32
8.5 Removing Pistons
1. Use a wrench and turn the pinion counterclockwise until the pistons (14) come out
of the body.
2. Remove the piston bearings (15), piston rack bearing strips (17) and piston o-ring
seals (16). Discard these parts.
Figure 24 Removing Pistons
17
14
16
15
15
16
17
14
Installation, Operation and Maintenance Manual
DOC.IOM.EF.EN Rev. 7
September 2017
31
Section 8: Disassembly