Emerson EL-O-Matic F Series - C.2 Convert a standard actuator into a Full Stroke Adjustment version

Appendix
C.2 Convert a standard actuator into a Full Stroke
Adjustment version
Before starting to assemble the Full Stroke adjustment kit, please check the kit for com-
pleteness. See gure C-2.
Figure C-2 Full Stroke adjustment kit content
41 42 43 44
45 46 11
40 9 10
12
13
Table C-1 Content Full Stroke Adjustment kit
Pos. Description Material Qty. Notes
40 End cap - Full stroke adjustment Cast Aluminium alloy 2 1
41 Full Stroke adjustment screw Stainless steel 2
42 Full Stroke adjustment Nut Stainless steel 2
43 Full Stroke adjustment washer PA66 2
44 O-Ring - Full Stroke adjustment screw Nitrile rubber 2
45 O-Ring - Thread bush Nitrile rubber 2
46 Thread bush Aluminium 2
9 End cap screw Stainless steel 8
10 Washer end cap screw Stainless steel 8
11 O-ring end cap Nitrile rubber 2
12 Warning sticker DA Full Stroke adjustment Polyester 2
13 Warning sticker SR Full Stroke adjustment Polyester 2
2. The same Full Stroke adjustment end cap is used for both double acting and spring return actuators
(at double acting actuator end caps with Full Stroke Adjustoment options are not available).
58
September 2017
Installation, Operation and Maintenance Manual
DOC.IOM.EF.EN Rev. 7
Appendix