Emerson EL-O-Matic F Series - 9.1 Grease Instructions

Reassembly
9.1 Grease Instructions
Check the product coding on the product labels and chapter 3 of this manual, to dene
which type of grease to use.
- For standard actuators (-20°C to +80°C / -4°F to +176°F):
Castrol High Temperature grease (or equivalent).
- For low temperature operation (-40°C to +80°C / -40°F to +176°F):
Castrol Optitemp TT1 or LG2 grease (or equivalent).
- For high temperature operation (-10°C to +120°C / 14°F to +248°F):
Castrol High Temperature grease (or equivalent).
We recommend using a suitable sized paint brush to apply the required amount of grease
on the parts as per Table 12 and Figure 23.
Table 13. Grease Instructions
Part Section of part Amount of grease
O-rings: A Completely Light lm
Housing Parts:
B Piston bore Light lm
C Top pinion bore Light lm
D Bottom pinion bore Light lm
Piston Parts:
E O-ring & bearing groove Light lm
F Rack teeth Half the teeth depth full with grease
G Piston bearing Light lm on outside
H Piston rack bearing strip Light lm
Piston Parts:
J Pinion bottom & O-ring groove Light lm
K Pinion top & O-ring groove Light lm
L Gear teeth Half the teeth depth
M Pinion top bearing Light lm (inside and out)
N Pinion bottom bearing Light lm (inside and out)
Figure 26 Grease Instructions
A
E
F
G
H
C
A
K
J
M
L
A
A
A
A
B
N
D
Installation, Operation and Maintenance Manual
DOC.IOM.EF.EN Rev. 7
September 2017
35
Section 9: Reassembly