Section: 9 Reassembly
This section explains:
• Which parts and how to grease them.
• How to reassemble a complete actuator.
• How to set the stroke adjustment bolts after reassembly.
• How to do a basic function and air leak test.
Tip
The instructions of this section can be used for maintenance or reconguration like spring
set change or maintenance.
Reference numbers for components refer to the exploded view in section 11.
In case of maintenance, discard all used soft parts like O-ring seals, guide bands and wear
strips and circlip and replace them with the parts as supplied in the repair kit.
In case of reconguration replace the parts as supplied in the conversion kit
(see also chapter 6).
Refer to the Safety Guide for Lifting Instructions.
NOTICE
The actuator is designed to be installed, commissioned and maintained using generic tools
like wrenches, Allen keys and screwdrivers.
Refer to the tables in this section or refer to Appendix B Tool and Torque tables.
34
To Next Page
Loading...
