Emerson EL-O-Matic F Series - Page 60

Appendix
Table B-3. NAMUR (VDE/VDI 3845) flanges
Flange
Metric Torque (Nm) Imperial Torque (lbf.ft)
Thread Min. Max. Thread Min. Max.
Solenoid ange screw threads M5 2.0 3.0 10-24UNC 1.5 2.2
Top ange screw threads M5 2.0 3.0 10-24UNC 1.5 2.2
Table B-4. Limit stop screws
Actuator size Thread
Bolt Wrench Nut wrench
size (mm) size (mm)
25 M 6 10 10
40 M 8 13 13
65 M 10 17 (16)
1
17 (16)
1
100 M 10 17 (16)
1
17 (16)
1
150 M 10 17 (16)
1
17 (16)
1
200 M 12 19 (18)
1
19 (18)
1
350 M 16 24 24
600 M 20 30 30
950 M 22 12 32
1600 M 24 14 36
2500 M 27 17 41
4000 M 22 12 32
1. Default dimension according DIN933 standard
2. Dimensions in brackets according ISO4017 standard
3. Actuator size 12 is not available with limit stops
Table B-5. Recommended circlip pliers according DIN 5254 (or equal)
for shaft circlips
Actuator
size
Pinion top
diameter
Pliers
according DIN
Actuator
size
Pinion top
diameter
Pliers
according DIN
F12 16 mm 0.630" A1
950 65 mm 2.559" A3
F25 - F100 22 mm 0.866" A2
1600 75 mm 2.953" A3
F150 - F350 36 mm 1.417" A3
2500 95 mm 3.74" A4
F600 55 mm 2.165" A3
4000 96 mm 3.78" A4
Table B-6. Angular Displacement Limit Stops
Actuator size
Turns for 5°
adjustment of the pinion:
360° revolution of
limit stop screw will adjust
F 12 Actuator size 12 is not available with limit stops
F 25 0.7 7.1°
F 40 0.8 6.3°
F 65 0.6 8.3°
F 100 0.7 7.1°
F 150 1.2 4.2°
F 200 1 5.0°
F 350 0.8 6.3°
F 600 0.8 6.3°
F 950 1.1 4.7°
F 1600 1.3 4.1°
F 2500 1.5 3.4°
F 4000 3.2 1.6°
56
September 2017
Installation, Operation and Maintenance Manual
DOC.IOM.EF.EN Rev. 7
Appendix