Emerson FB1100 - Removing the Front or Rear End Caps

FB1100 Flow Computer Instruction Manual
D301752X012
November 2023
18 Installation
Figure 2-3. Retaining Clamp in Place
To loosen or tighten the screw, use a 3mm hexagonal wrench. When tightening, torque to
12 in-lbs (1.4 N m).
Figure 2-4. Retaining Clamp and Screw
2.6.2 Removing the Front or Rear End Caps
DANGER
EXPLOSION HAZARD: Never remove end cap(s) in a hazardous location. Removing end
cap(s) in a hazardous location could result in an explosion.
Note
If you need more leverage place a long screwdriver or other appropriate tool across the
two notches in the end cap to act as a pry bar (see Figure 2-5).
Figure 2-5. Removing or Tightening the End Cap with Long Screwdriver
1. Remove the retaining clamp (if present). (See Section 2.6.1.)
2. Grasp the end cap (front or rear).