FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
92 Service and Troubleshooting
EXPLOSION HAZARD: Ensure the area in which you perform this operation is non-
hazardous. Performing this operation in a hazardous area could result in an explosion.
EXPLOSION HAZARD: Do not disconnect equipment unless power has been removed or
the area is known to be non-hazardous.
EXPLOSION HAZARD: Substitution of any components may impair suitability for Class I,
Division 2.
EXPLOSION HAZARD: Do not replace batteries unless power has been switched off or the
area is known to be non-hazardous. Batteries must only be changed in an area known to
be non-hazardous.
There are no user-serviceable parts inside the battery pack. Do not open the battery
pack as you may damage the battery pack or injure yourself.
Restriction
Battery packs cannot be used with ATEX or IECEx applications.
You will need a Phillips-head screwdriver to perform this procedure.
Keep the replacement battery pack handy during the procedure.
1.
Remove the plastic tabs covering the connectors on the new battery pack.
To Next Page
Loading...
