FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
32 Installation
Rotating the Housing
To improve accessibility to the HMI module or to ease wiring, you can optionally rotate
the housing.
Note
Never rotate the housing more than 180 degrees from its original (as-shipped) position.
Over-rotation can break electronics within the unit.
Figure 2-20. Housing Rotation Set Screw (1 each side)
Set Screw (one each side)
EXPLOSION HAZARD: Ensure the area in which you perform this operation is non-
hazardous. Performing this operation in a hazardous area could result in an explosion.
1. Loosen the two housing rotation set screws.
2. Rotate the housing no more than 180 degrees from its original (as-shipped)
position.
3. Re-tighten the two housing rotation set screws. Torque to 6 in-lbs. (0.7 N m).
To Next Page
Loading...
