FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
10 Introduction
front cover glass over the Hold to Wake button (the left-most button) for typically from
five to ten seconds.
1.10. Software Tools
The FBxConnect configuration software provides a series of wizards that allow you to
perform configuration activities for the flow computer. You connect a PC running the
FBxConnect configuration software to the flow computer using one of the communication
ports or through a wireless connection. You can then:
Set parameters within your application
Configure I/O channels
Specify the serial communication method for a port (RS-232 to RS-485) as needed
View or collect audit trail information such as alarm, event, or historical logs
Update system firmware
1.11. RoHS2 Compliance
Device without Integral MVS or SP Sensor:
RoHS (2) EU Directive 2011/65/EU
Device with Integral MVS or SP Sensor:
RoHS (2) EU Directive 2011/65/EU: This product may be considered out-of-scope when
used for the intended design purpose in a Large Scale Fixed Installation (LSFI).
Consult https://www.emerson.com/compliance for up-to-date product information.
1.12. Physical Security
The flow computer enclosure includes provision for you to padlock the door shut. The
fiberglass enclosure supports two padlocks (left in Figure 1-6); the aluminum enclosure
supports one padlock (right in Figure 1-6).
To Next Page
Loading...
