Emerson FB2100 - Environmental Specifications; Required Tools

FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
14 Installation
2.2. Environmental Specifications
This section summarizes the environmental specifications for the device. For full details,
refer to the product data sheet
41T
FB2100 Flow Computer
41T
(D301791X012).
Table 2-1. Environmental Specifications
Specification
Configuration
Range
Aluminum
Enclosure
Fiberglass
Enclosure
Ambient
Temperature
No battery, C1D2
40°C to +80 °C
(-40 °F to +176 °F)
-35 °C to 80 °C
(-31 °F to 176 °F)
No Battery, C1D2,
Relay installed
-40 °C to 60 °C
(-40 °F to 140 °F)
-35 °C to 60 °C
(-31 °F to 140 °F)
Lead Acid Battery,
C1D2
-40 °C to 45 °C
(-40 °F to 113 °F)
-35 °C to 45 °C
(-31 °F to 113 °F)
ATEX/IEC Ex ec
No Battery
-25 °C to 55 °C
(-13 °F to 131 °F)
-25 °C to 55 °C
(-13 °F to 131 °F)
Humidity
5% to 95% non-condensing
Vibration
2g over 10 to 150 Hz; 1g over 150 to 200 Hz
2.3. Required Tools
Certain tools and equipment are required for installing and servicing the flow computer.
Table 2-2. Required Tools
Tool
Use
Torque wrench
For bolting/mounting the flow computer
2.5 mm hexagonal wrench
For manipulating rotation set screw
#1 Phillips-head
screwdriver
For screws on HMI module
#2 Phillips-head
screwdriver
For screws on other modules and boards
#3 Phillips-head
screwdriver
For optional aluminum enclosure clamps
1/8 inch flat-head
screwdriver
For 5.08 mm pitch terminal block connections
7/32 inch flat-head
screwdriver
For installing external solar controller
Utility knife
For installing external solar controller
Wire cutters
For installing external solar controller